Description:
1.Air nailer light weight and well balanced for easy operating.
2.Superior power with hardened one piece piston for professional application.
3.Air nailer open nose design, for easy extraction of a jammed nail.
4.Tool free depth of drive adjustment, for flush or countersunk drive into varying material.
5.Hardened claw tip, reduces wear and limits slippage when driving at a stand angle.
RongPeng Professional Coil Pallet Nailer MCN90 :
Model
MCN90Dimension366*373*132 mmWeight4.12kgRequired pressure70-110PSI(4.8-7.5bar)Max.Pressure120PSI (8.3bar)Nail Capacity200-300PCS
Air Nailer Trouble Shooting: Symptom Problem Solutions Air nailer's leak near top of tool or in trigger area
1.O-ring in trigger valve are damage
2. Air nailer's trigger valve head are damage
3.Air nailer's trigger valve stem, seal or O-ring are damaged
1.Check and replace O-ring
2.Check and replace
3.Check and replace trigger valve stem, seal or O-ringAir Nailer's leak near bottom of tool
1.Loose screws
2.Worn or damaged O-ring or bumper
1.Tighten screws
2.Check and replace O-ring bumperAir leak between body and cylinder cap
1.Loose screws
2.Worn or damaged O-ring or bumper
1.Replace bumper
2.Adjust the air pressureBlade driving fastener too deep
1.Worn bumper
2.Air nailer pressure is too high
1.Verify adequate air supply
2.Place 2 or 6 drops of oil into inlet
3.Check and replace O-ring or seal
4.Replace damaged air nailer internl partsAir nailer does not operate well: can not drive fastener or operate slugishly
1.Inadequate air supply
2.Inadequate lubrication
3.Worn or damaged air nailer's O-ring or seals
4.Exhaust port in cylinder head is blocked
1.Verify adequate air supply
2.Place 2 or 6 drops of oil into air nailer's inlet
3.Check and replace O-ring or seal
4.Replace damaged internl partsTool skips fasteners
1.Worn bumper or damaged spring
2.Dirt in front plate of the air nailer
3.Dirt or damage prevent fasteners from moveing freely in spray gun's magazine
4.Worn or dry air nailer's O-ring on piston or lack of lubrication
5.Cylinder cover air nailer's seal leaking
1.Repalce bumper or pusher spring
2.Clean drive channel on front plate
3.Air nailer's magazine needs to be cleaned
4.O-ring need to be replaced and lubricate
5.Replace sealing washerTool jams
1.Incorrect or damaged fasteners
2.Damaged or worm driver guide
3.Air nailer's magazine or nose screw loose
4.Air nailer's magazine is dirty
1.Change and use correct fastener
2.Check and replace the driver
3.Tighten the magazine
4.Clean the magazine
Main Products