Sinosal 65W 2-Port Wall Charger PD 3.0 [GaN Tech] USB Fast Charging Power Delivery Adapter with Foldable Plug

Outline
This product is a fast charger.Its output power is 65W, the output is PD3.0+QC3.0.This document contains the electrical, mechanical and reliability requirements for this product.This product fully complies with all parameters and drawings involved in this specification.This adapter conforms to GB 4943.1-2011;EN 55022:2010, EN 55024:2010, EN 61000-3-2/A2:2009, EN 61000-3-3:2008;The CLASS Ⅱ requirements.
1.Safety Character
Item
Requirement
Test Condition≤0.25mA
Input voltage:264VAC/50Hz≥10Mohms
A voltage of 500VDC applied to the input and output. The insulation resistance should not less than 10MΩ.3000VAC
A voltage of 3000Vac applied to insulation for 60 s. There shall be no insulation breakdown after the test.GB4943.1-2011
2 Input Character100-240VAC90-264VAC50/60Hz1500mA maxSingle port:USB-A:5V/3A,9V/2A,12V1.5A
TYPE-C1:PD3.0 5V/3A,9V/3A,12V/3A,15V/3A,20V3A
TYPE-C2:PD3.0 5V/3A,9V/2A,12V/1.5A
Multi-ports:C1+C2:C1-PD3.0(45W),C2-PD3.0(18W)
C1+A:C1 PD3.0(45W),A(18W)
C2+A:share 5V/3A
C1+C2+A:C1-PD3.0 45W,C2&A-share5V/3AMeasured at 120V input voltage, surge current should less than 60A within 10mS.When the input voltage is 230V AC, Charge at 25%-50%-75% full load and rated input voltage,Charger efficiency > 86.8%When the input voltage range varies from 100V AC to 240V AC, With no load,The input power of this product should be < 0.3w.
3.Output CharacteAt the rated input voltage, frequency with no-load, the output
voltage changes from: -0.25 to +1VDC
Min. voltage:4.75VDC
Max.voltage :21VDC
( Note: Measured max. voltage with no-load is 21VDC) The appliance can keep operating with short-circuit output without
any damage. Adapter can automatically recover the normal
operating state with short-circuit disconnected; While in short-
Circuit output, Adapter enter the short-circuit protection
mode.While the load current reach or exceed peak current protection,
Adapter shall start current protection, the peak current less than 4A(230VAC).Auto-recovery115VAC Full load Max time :10mS115VAC full load (Time output voltage rise up from 0V to 5V) Max time :100msOn delay is <3S(Input AC115V)Adapter output is supplied a 10uF electrolytic capacitor and 0.1uF
ceramic capacitor, measured the voltage ripple and noise at different of
input voltage with full load. The oscillograph was set at 20MHz, the
output voltage ripple less than 200mVp-p.10%Max,When power supply at turn on or turn off.