SE8307- SMT glue printing adhesive SMT Red glue SMT adhesive

Properties Uncured (day@25°C) 14 90-120s at 120°C.
60-90s at 150°CPerformance After Cured
(Cured for 30min@150°C)
Physical Property Typical ValueTest SstandardHardness ( ShoreD )81 GB/T2411-1980 Shear Strength(MPa) 14.8GB/T7124-1986 Tg(°C)(DSC)98 ASTM E1545 Dielectric strength(KV/mm) 27.5 GB/T408.1-1999 Surface resistance (Ω)3.4x1016 GB/T1410-2006
Heat strength
(30min at 150°C)
Shear Strength(MPa)AL-AL
Direction For Use
The product should be recovered to room temperature before use, don't open the aluminum foil package before recovered to room temperature(the recovering time of 300ml packaging at least 2-4 hours).
The product should be used at 25°C ,
The glue viscosity will decline under the higher temperature, which influence printing effect; High humidity can increase the glue of moisture absorption which shorten the opening hours of the glue and influence the glue bonding strength. This product opening time is 48 hours at 25 °C,55% Rh.
Suggest to print at the speed of 20-150 mm/s; Drawknife pressure is 3-4 N/cm (Afer scraping, sheet should be clean, and avoid producing wire drawing); the deviating speed from the sheet is 0.1 3.0 mm/s.
Not cured adhesive which is stick on line wires can be erased with acetone or propylene alcohol ethers.
please seal and chill when not using up the glue.
Notice
Keep away from children.
The workshop should be adequate ventilation.
Wash with soapy water if on skin.
Wash with a lot of soapy water and then go for doctor if in eyes.
For more information, please refer to MSDS.
Package
NO: 6414034 300ml
NO: 6414054 200ml
Storage
6 months sealed at 2-8°C.