16mm drip tape with flat emitter agriculture drip irrigation tape

16mm drip tape with flat emitter agriculture drip irrigation tape
In-line drip irrigation pipe (tape)
Drip irrigation pipe use plastic tube to deliver water to the root of the crop through a hole or dripper on a capillary tube approximately 16 mm in diameter for local irrigation.
It is the most effective water-saving irrigation method in the current drought-stricken areas, and the water utilization rate can reach 95%. Compared with sprinkler irrigation, drip irrigation has higher water-saving and yield-increasing effects, and can be combined with fertilization to increase fertilizer efficiency by more than one time. It can be applied to fruit trees, vegetables, cash crops and greenhouse irrigation, and can also be used for irrigation of field crops in dry and water-deficient areas. The shortcoming is that the dripper is easy to scale and block, so the water source should be strictly filtered. diameter(mm)
Wall thickness(mm)
Drip spacing(cm)
Single roll length(m)
16
0.2
30
2500
0.25
2500
0.3
1500
0.4
1000
0.5
800
0.6
800
16
0.2
20
1500
0.25
1500
0.3
1200
0.4
1000
0.5
800
0.6
600
16
0.25
15
1200
0.3
1200
0.4
1000
0.5
800
0.6
600
16
0.25
10
1200
0.3
1200
0.4
800
0.5
600
0.6
400
Executive standard: GB/T19812.3 (where the pull-proof performance is subject to negotiation between the supplier and the buyer)
Features: water saving, fertilizer saving, labor saving.
Control temperature and humidity.
Maintain soil structure.
Improve quality, increase production and increase efficiency.
Scope of application: Widely used in drip irrigation projects of various crops such as field crops, solar greenhouses, vegetables, fruit trees, flowers, etc.
Precautions for use:
1. When the drip tape is used under the film, the surface water evaporates due to sunlight, and condenses into small water droplets in the film. These small water droplets form a lens. At an appropriate distance, the sunlight rays are focused by the water lens to form a glowing light. Point, this spot will burn the wall of the drip irrigation or burn out a small hole. To prevent such problems, the following precautions should be taken when using:
*Use dark mulch film, it is best to use black mulch film. If transparent film is used, drip irrigation should be buried or a thin soil layer should be covered on the mulch film to prevent strong light from penetrating the mulch film;
* Try to keep the ground level, and apply proper amount of pre-emergence herbicide in the soil before planting to prevent weed growth or soil block lifting the soil film, causing water vapor to accumulate water in the film to form small water drops;
2. When the insects are found to grow, the appropriate amount of insecticide should be sprayed to kill the insects in time to prevent the crop drip irrigation tape from being bitten and damaged.
3. When using mechanically laid drip irrigation tapes, it is necessary to prevent possible damage (breakage) caused by mechanical equipment and pull the drip irrigation tape.
4. When laying the drip irrigation tape, the side with the dripper should be facing upwards, and the force should be evenly distributed when pulling it, keeping the drip irrigation tape naturally straight.
5. It is not allowed to use the road through the field tillage operation, and it is forbidden for the machinery and livestock to crush and trample the drip irrigation tape.
6. The irrigation water entering the drip zone must be treated with a filtration system greater than 100 mesh.
Special statement:
The company will not be responsible for any damage to the drip tape or failure to use it properly if it is not operated in accordance with the above instructions.