Ceramic Clay Vacuum De-airing Pug mill

Ceramic Clay Vacuum De-airing Pug mill
Performance and Applications
TC200 type vacuum pug mill is special ceramics, electrical porcelain, porcelain, building porcelain, art porcelain, refractories and other industries ideal mud material refining equipment.
With advanced structure, stable and reliable performance, wide applicability, low noise, easy maintenance and maintenance, is the ideal production equipment.
Main Technical Parameters
1, screw diameter φ200
2, the machine nozzle diameter φ100-φ160
3, sludge moisture content 18%~ 30%
4, 1-2 t/h production capacity
5, vacuum - 0.095 Mpa
6, rotational speed 16.5 r/min
7, power 7.5 KW
8, overall dimensions (length x width x height) 2682 * 1025 * 817
9, form a complete set of vacuum pump is recommended to use 90m³/h,-0.098Mpa Product Description
Equipment Installation
Bolt of the extruder main land and fixed on the basis of the concrete, adjust, control box in the host back position (see photo) appearance with kerosene tank cleaning carefully before assembly, hose inner hole, pipe joints, etc., to prevent pollution of the oil system.
The control box with two rubber oil block linked with the hydraulic oil cylinder on the host.
Equipment Debugging
1. Debug should do the following work before
(1) in kerosene dry cleaning tank, through the air filter into N46 hydraulic oil 90L
(2) unscrew the pump discharge pipe, filled with hydraulic shaft, and tightening again.
(3)The relief valve to the "reduced" direction, the pressure gauge switch to "on", the volume of the valve handle clockwise rotation to the place.
(4) open the total power switch, motor running, start button, observe the pump rotation direction is correct.
2, the preparation work is completed at the beginning of the whole machine commissioning
(1) can be carried out when the pressure and flow rate (the extruder temporarily not charging) open the power switch on the control box, indicator lights on the electrical box, press the "motor start" button, "piston down" button, and later to the punch stop at the bottom, and then slowly turn the overflow valve regulating handle in the direction of "gain", at the same time observe the pressure gauge, pressure increased, transferred to the appropriate pressure, the lock handle back mother. The piston to run freely, and then make the punch up to the highest position.
(2) accurate setting pressure and flow in the cylinder bottom mount extrusion die, the barrel was full of mud material, cover rubber gasket, restore cylinder "drift" button, the molding blank out slowly from the lower mold is.
Molding billet extrusion pressure by adjusting the overflow valve handle (maximum working pressure 25 mpa) or less.Company Information
BRIEF INTRODUCTION OF OUR COMPANY
HebiHeLongSpecialEquipmentCo.,Ltd.
(theformerHebiWirlessSpecialMachineryfactory)
isacompanyengagedinspecialceramicmachinerymanufacture.Helongcompanywas
establishedin2004.basedonthepersonwithability,richtechnicalstrength,advanced
management,theproductshavebeenupdatedconstantly,andourfactorymaysatisfythe
customerrequirement.CompanypossessofmuchPATENT,especiallythevacuumextruding
machinehasachievedtheadvancedlevelofinter.Theproductshavereplacedthe
importation,andarefarsoldtooverseas.