Triac Dimmable Power Supply 12VDC 5Amp UL Class 2 Voltage LED Driver 12V 5A 60W
Product Features:UL8750 Class2Nema 3R - Outdoor useTriac, 0-10V DimmableDimming 8W Minimum LoadSuper compact Aluminum CaseConstant Voltage, Constant Current DimmingOCP/ OVP/ OTP/ SCP Preotections
Parameters: Item12VDCClass2VoltageLEDDriversPowerLoad60WOutputVoltage12VDCOutputCurrent5AmpInputVoltage120VACOutputCurrent0.72APowerFactor0.95Efficiency>90%WaterprrofLevelNEMA3RApprovalsUL8750&Class2OperatingAmbientTemperature-20℃-70℃(-4℉-158℉)ColorBlackShortcircuitprotectionyesOvercurrentyesOvertemperatureyesOpencircuitprotectionyesInputWires(WhiteBlack)18AWGOutputWires(Red+Blue-)14AWGHousingMaterialAluminumDimensionsL*W*H6.97”x2.76”x1.38”Weight640gProduct Pictures:
Driver Schematic:Enclosure Detailsin(mm) : Length6.97 (177)Width2.76(70)Height1.38(35)
seline;">12-Volt DC Installation Guide:Highly efficient, stablized, constant voltage DC power for LED lighting
60W 12V 5A Class 2 Voltage LED Driver (UL Listed)
General
•This driver is to be installed in accordance with Article 450 of the National Electric Code and installed by qualified and professional electrician.
•Please make sure the driver is installed with adequate ventilation around it to allow for hear dissipation.
Before Installing
•Power must be disconnected at all times during installation.
•Observe polarity of the 12volt DC output. Failure to observe polarity could damage LED lighting.
•Total wattage of all LED fixtures used must not exceed the maximum watt rating of the power supply.
Input Connections / Grounding
•Use the clamp connectors to secure cords and wires.
•Route and secure wires so they will not be pinched or damaged.
•All wiring must be in accordance with national and local electrical codes, low voltage Class 2 circuit. For wire runs inside of walls, use properly certified CL2 or better cabling and appropriate mounting hardware. If you are unclear as to how to install and wire this product, contact a qualified electrician. Failure to install this device properly may result in electrical shock or fire.
•Do not install Class 2 low voltage wiring in the same runs as AC main power. If AC and low voltage wires across, keep them at 90-degree angles.
•The driver case MUST be grounded in accordance with the N.E.C. Connect the ground wire to the driver green wire.
Output Wire
•Bring the wires of the light fixture through the other clamp connector and connect them to the driver wires - positive to the red (+) wire and negative to the blue (-) wire.
Dimming
•Dimmable with any standard MLV/Incandescent TRIAC (Leading edge) dimmer switched.
•Dimmer switched is to be installed on the input (120VAC side) of the driver.Company InformationOur ServicesFAQ
Need samples and any requests welcome to contact us<<<<<<