IP-500 Injection Pump
Data.:
Pressure: 10000psi
Flow: 0--60MPa / 2.8 L / min
Power: 220 V / 50 Hz
Net weight: 6Kg
Largest output pressure: 11000psi
Accessories:
Injection pump 1 pcs
Material Cup:1 pcs
High pressure pipe :1 pcs 5 metres
Controller : 1pcs
Rubber pad: 5pcs
Drill : metado sb560 1pcs
Repair Kit: 1pcs
Extension line : 1pcs
Filter: 1 pcs
Features:
1.Environmental protection: mechanical performance is good, no noise, no pollution
2.Portable: small size, light weight, easy to carry, easy to operate
3.High efficiency: in a few seconds to reach 0 ~ 5Mpa work pressure. Advanced industrial, labor-saving, time-saving and high efficiency.
4.Security: technical, reliable, reasonable structure, use of safety.
5.The pressure continued: Continuous high-pressure can effectively be made by the Pharmacy within the structure of cracks, micro-suture, micropore, capillary fill plug.
6.Structural non-destructive: the cracks in a direct line installed near the mouth of grouting grouting, non-tick slot, not pipe, structural non-destructive.
7.With water plug: For a variety of gap leakage, wave leakage, underground water gushing. Grouting plugging directly with water. Could effectively inject grout into the cracks in the depths.
8.Supporting the use of a wide range of materials: polyurethane, epoxy resin, acrylic resin, such as the annual non-serous granular materials can be used.
9.Multi-functional: a multifunctional computer, and plugging grouting, cracks, grouting reinforcement.
10.Durable: the maximum pressure of 50MPa when the body parts are not deformed. Maintenance simple and easy maintenance, strong and durable, easy to clean.1.Low viscosity, starting immediately in contact with water and foam chemical screening expansion.
2.Super-structure reinforcement, high-expansion ratio, toughness good, does not shrink.
3. Strong adhesion and good chemical resistance.
4.Drinking water contact the area may also be used.
5.Suitable for single-fluid-pressure perfusion machines and other equipment.