addressable apa102 matrix 16x16 pixel panel with flexible black PCB

addressable apa102 matrix 16x16 pixel panel with flexible black PCBProduct parameter LED ChipSMD5050 RGB LED chipIC ChipAPA102 IC built-in 5050 RGB LED chipLED Quantity256LEDs/mInput VoltageDC5VWatts75W/MaxIP RateIP20(non-waterproof)PCB ColorBlack PCBView Angle140°ColorAddressable full colorPCB Pitch10mmPCB Size160mmx160mmWarranty2 yearsBrandiPixel LEDProduct Description
1.Individually addressable RGB LEDs (16*16 LEDs)
2.24-bit color control (8-bit PWM per channel); 16.8 million colors per pixel
3.Additional color-independent brightness control (5-bit PWM); 32 brightness steps per pixel
4.SPI control interface
5.5 V operating voltage
6.Each LED Matrix draws approximately 8A at full brightness
7.160 mm width (16 LEDs) or 160 mm width (16LEDs) Pitch : P10
8.Flexible,bendable IP20 rating
9.Black strip color
10.Power/data connectors on both strip ends for easy chainingProduct DetailsConnection Way
1.There's a new square design LED matrix iniPixel LED!16*16 Pixel APA102C LEDs
use a 2-wire SPI,it can push data much faster than with the WS2812B 800 KHz
protocol and there's no specific timingrequired. it's also have much higherPWM refresh rates.
2.This SMD 5050 LEDs is GRB color sequence ,not RGB sequence !!!
with an embedded microcontroller inside the LED. You can set the color/brightness of each
LED to 24-bit color (8 bits each red green and blue). Each LED acts like a shift register, reading
incoming color data on the input pins, and then shifting the previous color data out on the
output pin. By sending a long string of data, you can control an unlimited LEDs
3.These LEDs have 2 wires (input and output) for clock and one data pin.
Because the clock and data is seperated, you can use any microcontroller or microprocessor,
including Arduino, Raspberry Pi, BeagleBone, Propeller to control it
PWM rate. You only have to set the 24-bit color data for each pixel LED once, and then the
LED+built-in-chip will handle the PWMing of the red, green and blue.
On our WS2812B Matrix, this PWM rate happens 400 Hz, which works well but is noticably
at lower brightnesses and if the strip is moving in any way. have a 20 KHz PWM rate, even if
you set any color or animation, there is no pixelation
4.The Matrix is made of flexible PCB material,Non-waterproof ,for indoor use only, 2 Ounce
copper PCB and black color you can also connect each matrix to together to make them as
large as a P10 LED screen, make sure gave them enough Power , each matrix 256 pcs LEDs
request about 8A.These matrix comes in 1pcs per bag, on the back side, soldered a pair of
4-pin JST SM connector, it's makes easy to link to next matrixCompany InformationPackaging & Shipping