Building Fast dry waterproof coating for concrete

Product Description
Cheap and high quality Polyurethane Waterproof Coating
1. Product introduction
Water curing group divided into polyurethane waterproof coating is in the wet curing and latent curing group divided into polyurethane waterproof coating based on research into another type of single group divided into polyurethane waterproof coating is a new generation of environmentally friendly type waterproof coating.
2. Advantages
One component packaging, open a barrel that is used to avoid the construction process of two or more components with improper measurement caused by the quality of the instability
One component packaging direct water curing, non-toxic, pollution-free.
The waterproof coating film has the characteristics of high tensile strength, high elongation at break, good weather resistance and strong adaptability to deformation.
3. Application Range
Roofing, underground waterproof engineering, indoor kitchen waterproof.
Parking, bridge, bridge deck waterproofing
Subway, tunnel and underground works
4. Key points of construction
Basic requirements: basic level should be smooth, no sand, no debris, uneven and primary deformation joint cracks shall be use cement mortar screed, connect with the grassroots of pipe fittings and sanitation, and floor drain must firmly, seams to be tight, to receive the first slick, not allowed to have loose phenomenon
The film construction: General requirements three times coating scraping, the first time film cure for 12-24 hours after the second layer brushing, scraping and the direction perpendicular to the first film direction, the three times of coating for the rigid protective layer, waterproof layer and rigid protective layer between the cohesive force, in the film has not yet been fully cured, in the sparse surface of the sprinkle clean sand, sand until the sticky film curing, rigid protective layer construction.
Details: first the Yin and yang angle, pipe root brushing a layer of paint, Putie reinforcing layer (glass fiber cloth or non-woven fabrics, etc.), and the coating completely soaked reinforcing layer.
5. Matters need attention
After the opening of a run out, the use of time for half an hour. When the product storage period is longer, the paint surface may form a thin layer of plastic film, when used to remove, does not affect the use effect.
Curing of coating construction of forbidden in the waterproof layer is walking, is strictly prohibited heavy and sharp objects damaged waterproof layer; construction site to keep the ventilation, construction personnel equipped with safety helmet, gloves, shoes and other protective supplies, to avoid skin and eye irritation, the construction site shall not contact ignition sources.
The restriction of the use of: snow, wind, cold weather
Company Information
Our Services
FAQ