New Item Anti Temperature Two Components Wood River Crystal AB Glue

Related Product Models ModelColorRatioViscosity
Curing time
25℃ HHardness,ShoreD119-1ABTransparent3:140001207-880211-1ABTransparent3:117001607-860211-3ABTransparent3:117001507-875211-2ABTransparent3:117001607-875
Technical Parameter Epoxy 211-3A Hardener 211-3BApprearance and CharateristicModel211-3A211-3BColorTransparent liquidTransparent liquidSpecific gravity1.150.10.80.1Viscosity7000-7500(CPS) 300-400(CPS)Usable MethodRatio
A:B=3:1(Weigh Ratio)
25℃*30-45minutes
25℃*3-4hoursUsable timeHardening conditionsProduct FeatureFast curing,High transparency,Anti-yellowing,Natural Defoaming,High Plumpness,High gloss
Notice: The above data is typical data measured by the laboratory environment under
the temperature of 25 ℃, and humidity of 70%. For customers’ reference only.
Properties after Hardening
Hardness, shore D
>86
Withstand voltage, KV/mm
22
Flexural strength, Mpa
75
Volume resistivity, Ω·cm
1.2x1014
Surface resistance, Ohmm2
5X1015
Withstand high temperature, ℃
92
Moisture absorption, %
<0.15
Compressive strength, Mpa
40
Caution
3, If contact skin, wrap with clean cloth or paper, and wash it with water and soap.
4, Keep away from children.
5, Please take a trial before application to avoid usage mistake.

Storage And Shelf Life

Warm prompt
One:what reason is glue occurrence does not stick and do not cure?
Answer:this type of glue must be in accordance with its ratio, and it is the electronic weight ratio, not the volume ratio. Also, look at the temperature. If it's too cold, it's recommended to heat it up to 25 degrees before stirrig.
Second: we do not have vacuum equipment, how to defoaming?
Answer: dear, there is no vacuuming equipment no matter, our glue is natural defoaming, glue thoroughly after mixing, stationary 5-20 minutes, can automatically defoaming.
Three: why is our glue seven days old and still not solidified?
Answer: if the product is hard glue for 3 days and soft glue for 7 days and still does not cure, 1. Please check whether the ratio is based on weight; 2. 2. Whether the stirring method is correct or not. Considering environmental protection and safety, the curing agent is water-based, which is as thin as water. 3. If you can confirm that there is no problem with 1 and 2, then this is very important. The proportion of A component +B component of the primary glue should be more than 50 grams, and the proportion must be weighed by electrons.
Four: glue mix mix which component first pour?
Answer: when mixing this product, please pour glue B into the blender, and then pour glue A.
Five: I still don't understand what to do?
Answer: then please contact our customer service, we are ready to serve you 24 hours a day.